Description Of Schematic Diagram; Voltage Measurement Conditions; Waveform Measurement Conditions - Sharp 29WF200 Service Manual

29WF200
29WF500

DESCRIPTION OF SCHEMATIC DIAGRAM

SAFETY NOTES:
1. DISCONNECT THE AC PLUG FROM THE AC OUTLET BEFORE
REPLACING PARTS.
2. SEMICONDUCTOR HEAT SINKS SHOULD BE REGARDED AS
POTENTIAL SHOCK HAZARDS WHEN THE CHASSIS IS OP-
ERATING.
IMPORTANT SAFETY NOTICE:
PARTS MARKED WITH "
MAINTAINING THE SAFETY OF THE SET. BE SURE TO RE-
PLACE THESE PARTS WITH SPECIFIED ONES FOR MAINTAIN-
ING THE SAFETY AND PERFORMANCE OF THE SET.
SERVICE PRECAUTION:
THE AREA ENCLOSED BY THIS LINE (
CONNECTED WITH AC MAINS VOLTAGE.
WHEN SERVICING THE AREA, CONNECT AN ISOLATING TRANS-
FORMER BETWEEN TV RECEIVER AND AC LINE TO ELIMINATE
HAZARD OF ELECTRIC SHOCK.
å
" ( ) ARE IMPORTANT FOR
) IS DIRECTLY
NOTES:
1. The unit of resistance "ohm" is omitted.
(K = 1000 ohms, M = Meg ohm).
2. All resistors are 1/16 watt, unless otherwise noted.
µ
3. All capacitors are F, unless otherwise noted. (P =

VOLTAGE MEASUREMENT CONDITIONS:

1. Voltage in parenthesis measured with no Signal.
2. Voltages without parenthesis measured with PAL Colour-
Signal.
3. All the voltages in each point are measured high impedance
volt-meter.

WAVEFORM MEASUREMENT CONDITIONS:

1. Colour bar generator signal of 1.8V peak to peak applied at
Base of Video Buffer Amp. Q405.
2. Approximately 4.0 V AGC bias.
26
µµ
F).