Battery Installation - ION WATER ROCKER Quick Start Manual

11. SCAN button- Scans for the wireless receiving signal
12. SLEEP button- Selects the duration of the sleep timer
13. ST/MO button- Selects FM radio mode to be stereo or
mono
14. CH/ +/- button- Scrolls through the saved preset radio
station channels
15. Upper housing
16. Lower housing
17. Battery cover- Cover for the internal batteries
18. Battery cover lock - Secures the AA battery
compartment
19. Clock battery compartment
20. AA battery compartment
21. RESET button- Sets the speaker back to factory
defaults
Note: If the unit ever locks up or will not power on, try the
above mentioned reset.
INSTALLATION

Battery Installation

Transmitter
1. Open the battery compartment located at the bottom of the transmitter
2. Follow the polarity diagram located inside the compartment and install 3 AA
batteries
3. Close the compartment lid
Speaker
1. Wipe the speaker with a soft cloth to remove any water
2. Open the speaker by gripping the lower housing and turn it counter clockwise
3. Release the inner battery lock to open the cover
4. To install the batteries:
• When installing the clock battery, follow the diagram shown inside the clock battery compartment and install a
CR2032 lithium battery. If this speaker is being used for the first time, a battery is already installed. All you
need to do is remove the plastic cover tag from the battery slot to activate.
• When installing alkaline batteries to use the radio and wireless receiving, follow the polarity diagram shown
inside the compartment and install 6 AA alkaline batteries.
5. Close the inner battery cover and lock it
6. To close the speaker, grip the lower housing and turn it clockwise until it locks tight with the upper housing
Low battery detection
If the low battery detection indicator is displayed, replace the alkaline batteries.
Note: Remove the batteries if the speaker will not be used for an extended period of time.
ST
MO
4
TUN
SCAN
-
+
AA
-
+
AA
DC1.5V (UM-3) X3
-
+
AA