Table of Contents
Advertisement
Accessories
Accessories may have been shipped with your lawn
mower or are available from your Authorized Service
Dealer. For proper installation, follow these instructions.
Rear Grass Catcher
Installing the Discharge Tunnel
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug (Fig. 7).
3. Remove the knob and side cover clamp (Fig. 32).
Figure 32
1. Knob
2. Side cover clamp
4. Remove and save the three bolts that secure the
discharge cover to the lawn mower (Fig. 33). Save the
cover and bolts for future use.
2
Figure 33
1. Discharge cover
2. Bolt (3)
1
2
3
m–4275
3. Side opening cover
3
1
m–4275
3. Screw and nut
5. Remove the screw and nut from side of the lawn
mower (Fig. 33). Save them for future use.
6. Install four grommets supplied with the grass catcher
into the four square holes in the lawn mower (Fig. 34).
1
1. Grommet (4)
7. Insert the tongue of the discharge tunnel into the lawn
mower (Fig. 35).
8. Align the holes in the tunnel with the grommets in the
lawn mower (Fig. 35).
9. Ensure that the hole in the tongue aligns with the hole
in the side of the lawn mower (Fig. 35).
5
4
1. Discharge tunnel
2. Tongue
3. Self-tapping screw
10. Install the self-tapping plastite screw supplied with the
grass catcher into the side hole and tongue, and
partially tighten the screw (Fig. 35).
11. Using three screws supplied with the grass catcher,
fasten the discharge tunnel to the lawn mower
(Fig. 35).
23
Figure 34
4
1
3
2010
2
Figure 35
4. Bolt (3)
5. Discharge tunnel door
2009
Advertisement
Table of Contents
