Toro 04381 Operator's Manual page 16

Controls
forward to tighten adjustment.
Water Temperature Light (Fig. 10)—This light glows
and the engine automatically shuts-down when the
engine coolant temperature gets too high.
High-Temperature Override Button (Fig. 10)—If the
engine kills due to an over heat condition, press the
override button in and hold it there until the machine can
be moved to a safe location and allowed to cool down.
Note: When using the override button, it must be held
down continuously to operate. Do not use it for
extended periods of time.
Glow Plug Indicator Light (Fig. 10)—When lit, this
light indicates the glow plugs are on.
Battery Warning Light (Fig. 10)—Light glows if the
battery charge is low.
Oil Pressure Light (Fig. 10)—Light glows if the engine
oil pressure drops below a safe level.
Raise/Lower/Mow Control (Fig. 10)—Moving this
control forward during operation lowers the cutting units
and starts the reels. Pull back on the control to stop the
reels and raise the cutting units. During operation, the
reels can be stopped by pulling back on the control
momentarily, then releasing it. Restart the reels by
moving the control forward.
SEAT ADJUSTING HANDLE (Fig. 11)—The lever on
the left side of the seat allows seven-inch fore and aft
adjustment.
1. Seat adjusting handle
FUEL SHUT-OFF VALVES (Fig. 12 & 13)— Close the
fuel shut-off valves under the fuel tank and above the
fuel filter when storing the machine.
16
Figure 11
Figure 12
1. Fuel shut off (under fuel tank)
Figure 13
1. Fuel shut off (on fuel tank)