Table of Contents
Advertisement
Assembly
4.
Push rod full forward until bearing is against
control bracket stop. Thread rod in or out of
fitting on control bracket until rod aligns with
holes in upper control bars (Fig. 4).
5.
When rod and holes in upper control bars line
up, turn rod one (1) additional turn, so rod is
shorter.
Note:
Upper control bar stop must hit
reference bar before roller hits control
bracket stop.
6.
Connect rod to upper control bars with
previously removed hairpin cotter.
Figure 4
1. Control rod–left
2. Control bracket
3. Rod fitting
12
m–3064
4. Clevis pin
5. washer
6. Hairpin cotter
Right Control Rod
7.
Slide rod into control bracket and secure with
hairpin cotter (Fig. 5).
8.
Remove hairpin cotter and rod from upper
control bars.
9.
Press and hold upper control bars against
reference bar, so stop hits.
10. Push rod full forward until bearing is against
control bracket stop. Loosen wing nut and thread
turnbuckle in or out until rod aligns with holes in
upper control bars (Fig. 4).
11. When rod and holes in upper control bars line
up, rotate turnbuckle one (1) additional turn, so
rod is shorter.
Note:
Upper control bar stop must hit
reference bar before roller hits control
bracket stop.
12. Connect rod to upper control bars with
previously removed hairpin cotter, tighten wing
nut and turnbuckle.
Figure 5
1. Control rod–right
2. Control bracket
3. Hairpin cotter
m–3103
4. Wing nut
5. Turnbuckle
Advertisement
Table of Contents
