1. Manuals
  2. Brands
  3. Toro Manuals
  4. Lawn Mower
  5. WHEEL HORSE Series
  6. Setup instructions

Toro WHEEL HORSE Series Setup Instructions

For 32” and 38” mowers
Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual

Loose Parts

Note:
Use the chart below to verify all parts have been shipped.
DESCRIPTION
Front Wheel
Shim Washer (as required)
Flat Washer
Cotter Pin
Hub Cap
Steering Wheel
Spirol Pin
Seat
Knob
Flat Washer
Wire Clip (on seat pan)
Bolt 1/4–20 x 3/4"
Wing nut
Spring Hook
Key
Operator's Manual
Safety Booklet
Safety Video
Registration Card
Printed in USA
WHEEL HORSE LAWN TRACTOR
FOR 32" AND 38" MOWERS
QTY.
2
2
2
Install front wheels.
2
2
1
Install steering wheel.
1
1
1
Install the seat.
1
1
2
Install battery cables.
2
1
Used to install lift assist spring.
2
Use in ignition switch.
1
1
Read and watch before operating tractor.
1
1
Fill out and mail the card.
The TORO Company – 1997
All Rights Reserved
FORM NO. 3318–186 Rev. B
SET-UP
INSTRUCTIONS
USE

Advertisement

Table of Contents
loading

Related Manuals for Toro WHEEL HORSE Series

Summary of Contents for Toro WHEEL HORSE Series

  • Page 1: Loose Parts

    Used to install lift assist spring. Use in ignition switch. Operator’s Manual Safety Booklet Read and watch before operating tractor. Safety Video Registration Card Fill out and mail the card. The TORO Company – 1997 All Rights Reserved Printed in USA...

  • Page 2: Install Front Wheels

    Set-Up Instructions Install Front Wheels Install Steering Wheel Note: If wheels are already installed, refer to Move front wheels straight ahead. Check Tire Pressure (below). Slide the steering wheel over shaft. Line up the Install shim washers onto axle. hole in the steering wheel with the hole in the shaft (Fig.

  • Page 3: Activate The Battery

    Set-Up Instructions Thread the knob and flat washer into the rear center hole in the seat (Fig. 3). Adjust the seat and tighten the knob. POTENTIAL HAZARD Push the seat switch connector fully into the Battery electrolyte contains sulfuric acid wire harness connector (Fig.
  • Page 4 Set-Up Instructions Leave the filler caps off and connect a 3 to 4 Install the battery and battery box in the tractor: amp battery charger to the battery posts (Fig. 5). refer to the Operator’s Manual, Installing the Charge the battery at a rate of 4 amperes or less Battery.
  • Page 5 Set-Up Instructions Purge Hydro Transaxle Check Hydro Neutral Position (Hydro Drive Tractors Only) (Hydro Drive Tractors Only) During handling and shipping air can be introduced Adjustment is required if the tractor creeps without into the hydro transaxle. To achieve proper the traction control pedal being depressed.
  • Page 6 Set-Up Instructions Check Traction Control Pedal Check Shift Cable Adjustment (Hydro Drive Tractors Only) (Gear Drive Tractors Only) After adjusting the hydro neutral position it is Cable adjustment is required if the ground speed necessary to check the traction control pedal. While selector lever does not move firmly toward the pressing the control pedal full forward and full numbers on the shift plate when released or it is...

  • Page 7: Test Drive The Tractor

    Set-Up Instructions Test Drive the Tractor Move gear select lever and note gap between lever and edge of gate. There should be about 1/4 inch of free play before cable is taught. Make sure all electrical and mechanical systems are operating properly.

Table of Contents