Automatic Line Feed Repair - Toro 51603 Maintenance And Repair Manual

DISASSEMBLY, REPAIR,
REASSEMBLY INSTRUCTIONS
AUTOMATIC LINE
FEED
REPAIR
1. Drain the gasoline from the fuel tank and remove
the high tension wire from the spark plug.
2. Insert a medium flat screw driver in one of the
two window slots in the spool hub and twist. The
spool will snap off. (Fig. 26). NOTE: Use as wide a
screw driver as will fit in the slot so as not to
damage the cap.
Figure 26
3.
Hold the drum securely, and unscrew the spool
core counterclockwise. The driver will turn off
with
it.
4. Remove the washer and compression spring and
5. Clean the debris from the inside and outside of
the
drum
and remove any debris wrapped around
the, power shaft.
slide the drum off the power shaft.
6. Replace any worn or broken parts.
7 . Reassemble the trimmer head in the reverse
order. Be certain that the roll pin on the power
shaft is seated in the slot in the drum.
8 . The spool and spool core are keyed. They must be
properly aligned when putting the spool back on.
Thread the end of the line through the eyelet.
Plate the spool on the keyed core and push in
place until you hear
it
click.
18