Wiring Diagram; Cleaning And Storage - Toro 30169 Operator's Manual

Wiring Diagram

WIRE LIST
DESIG. AWG COLOR ROUTE
W1 16 PINK P2–1 J8
W2 16 WHITE P3–1 J7
W3 16 BLACK J1 P1–1
W4 16 BLACK P1–1 P3–2
W5 18 BLACK P3–2 P4–4
W6 16 PINK J3 P2–2
W7 16 PINK J3 P4–2
W8 16 GREEN P1–2 P4–3
W9 18 ORANGE J4 P4–1
W10 18 ORANGE J2 P4–1
W11 18 BROWN J5 J6
W8
2
P1
CLUTCH
W4
1
W3

Cleaning and Storage

1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to off. Remove the
key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean dirt and chaff from the outside of the
engine's cylinder head fins and blower housing.
Important You can wash the machine with mild
detergent and water. Do not pressure wash the machine.
Avoid excessive use of water, especially near the control
panel, and engine.
3. Check the brake; refer to Servicing the Brake, page 26.
4. Service the air cleaner; refer to Servicing the Air
Cleaner, page 22.
5. Grease the machine; refer to Greasing and Lubrication,
page 25.
J8
P2
CHARGE
FUSE
COIL
2 1
W6
W1
W3 W9
J1 J4 J5
GND BAIL SWITCH
J7 P3
MAGNETO IGNITION
1 2
W4
W5
W2
W11
J6
6. Change the crankcase oil; refer to Servicing the
Engine Oil, page 23.
7. Check the tire pressure; refer to Checking the Tire
Pressure, page 26.
8. For long-term storage (more than 90 days) add
stabilizer/conditioner additive to fuel in the tank
(1 oz. per gallon).
A. Run engine to distribute conditioned fuel through
the fuel system (5 minutes).
B. Stop engine, allow to cool and drain the fuel tank;
refer to Servicing the Fuel Tank, page 26, or
operate engine until it stops.
C. Restart engine and run until it stops. Repeat, on
choke until engine will not restart.
D. Dispose of fuel properly. Recycle as per local
codes.
Note: Do not store stabilizer/conditioned gasoline over
90 days.
29
W5
4
W8
3
P4
DELAY
MODULE
W7
2
W9
1
W10
J2
CLUTCH
SWITCH
W7
J3
W6