Others - Panasonic SC-RS52 Operating Instructions Manual

Others

Auto off function
As a factory default, this unit will turn to standby mode
automatically if there is no sound and it is not being
used for approximately 20 minutes.
To cancel this function
1
Press [SETUP] repeatedly to select "AUTO OFF".
2
Press [2, 1] to select "OFF" and then press [OK].
≥ To turn the function on, select "ON" in step 2.
≥ This setting cannot be selected when radio is the source.
≥ When connected to a Bluetooth
not work.
Bluetooth standby
®
When "SC-RS52" is selected from a paired Bluetooth
device's Bluetooth menu, this unit will turn on
®
automatically from standby mode and establish a
Bluetooth connection.
®
1
Press [SETUP] repeatedly to select "BLUETOOTH
STANDBY".
2
Press [2, 1] to select "ON" and then press [OK].
≥ To turn the function off, select "OFF" in step 2.
≥ The factory default is "OFF". If this function is set to "ON", the
standby power consumption will increase.
® device, the function does
®
Changing the unit and remote
control code
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1
Press [CD/ ] repeatedly to select "CD".
2
Press and hold [∫] on the unit and [2] on the
remote control until the unit's display shows
"REMOTE 2".
3
Press and hold [OK] and [2] on the remote control
for at least 4 seconds.
≥ To change the mode back to "REMOTE 1", repeat the steps
above but replace [2] with [1].
Software update
Occasionally, Panasonic may release updated
software for this system that may add or improve the
way a feature operates. These updates are available
free of charge.
For more details, refer to the following website.
http://panasonic.jp/support/global/cs/
(This site is in English only.)
Checking the software version
Press [SETUP] repeatedly to select "SW VER." and
then press [OK].
The version of the installed software is displayed.
≥ Press [OK] to exit.
17
RQT0A76