Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for grandimpianti 805898ENR1
- Page 1 Stacked Washer/Dryers Electric and Gas Models Original Instructions Keep These Instructions for Future Reference. (If this machine changes ownership, this manual must accompany machine.) SWD455C_SVG Part No. 805898ENR1 February 2015...
- Page 3 Installation and service must be performed by a qualified installer, service agency or the gas sup- W053 plier. This product uses FreeRTOS V7.2.0 (www.freertos.org). W052 © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT...
-
Page 4: Table Of Contents
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... - Page 5 Reinstallation of Shipping Materials............... 38 Motor Overload Protector................39 For Energy Conservation................39 Troubleshooting..................40 Disposal of Unit..................44 Contact Information................45 Installer Checklist.................46 © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT...
-
Page 6: Safety Information
Children less than three years should be kept away unless continuously supervised. • Do not reach into the washer if the washtub or agitator, if ap- plicable, is moving. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 7: Important Safety Instructions
Do not reach into the dryer if the cylinder is revolving. • Use the dryer only for its intended purpose, drying clothes. ALWAYS follow the fabric care instructions supplied by the © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... - Page 8 Always contact your dealer, distributor, service agent or the man- ufacturer about any problems or conditions you do not under- stand. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT...
-
Page 9: Dimensions
38 mm [1.5 in.] * 333 mm [13.1 in.] NOTE: Exhaust openings are 102 mm [4 inch] metal * With leveling legs turned into base. ducting. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... - Page 10 38 mm [1.5 in.] *333 mm [13.1 in.] NOTE: Exhaust openings are 102 mm [4 inch] metal * With leveling legs turned into base. ducting. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT...
- Page 11 38 mm [1.5 in.] *333 mm [13.1 in.] NOTE: Exhaust openings are 102 mm [4 inch] metal * With leveling legs turned into base. ducting. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT...
- Page 12 107 mm [4.2 in.] *104 mm [4.1 in.] *1184 mm [46.62 in.] *1986 mm [78.17 in.] 52 mm [2.04 in.] 704 mm [27.73 in.] Table continues... © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT...
- Page 13 For maximum drying per- formance, we recommend that more clearance be al- lowed around the dryer than the clearances that are lis- ted throughout this manual. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT...
-
Page 14: Installation
7. For gas models only, connect the gas supply pipe. Check for gas leaks. 8. Connect dryer to exhaust system. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 15: Position Unit Near Installation Area
3. Remove two 9/16 inch bolts and washers holding shipping FLW2358N_SVG brace to washer base and remove brace. Figure 6 7. Replace front access panel. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 16: Connect Fill Hoses
7. Continue tightening and rechecking until no leaks are found. kPa [minimum of 1.4 bar to a maximum of 8.3 bar] static pres- sure measured at the faucet. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 17: All Other Models
4. Thread hose couplings onto valve connections finger tight. Then turn 1/4 turn with pliers. IMPORTANT: DO NOT cross thread or overtighten couplings. This will cause them to leak. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 18: Install Washer Electrical Cord
Refer to Kit 805832 for converting to 230 Volt, Single-Phase, 2 wire plus earth, 21 Amp connec- tion. Have a qualified electrician install appropriate electrical recepta- cle. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 19: Non-Gravity Drain Models - Connect Drain Hose To Drain Receptacle
IMPORTANT: Drain receptacle must be capable of han- Figure 12 dling a minimum of 35 mm [1-3/8 inch] outside diame- ter drain hose. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 20: Gravity Drain Models - Connect Drain Outlet To Drain System
NOTE: The gas service to a gas dryer must conform Figure 13 with the local codes and ordinances. Gas Dryers - Connect Gas Supply Pipe © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... - Page 21 For proper operation at altitudes above 1370 m [4500 feet] the L.P. gas valve spud orifice size must be reduced to ensure com- plete combustion. Refer to Table 2 . © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT...
-
Page 22: Connect Dryer Exhaust System
• Ductwork that runs through unheated areas must be insulated W048 to help reduce condensation and lint build-up on pipe walls. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 23: Exhaust Direction
16.8 m [55 feet] 16.8 m [55 feet] 14.3 m [47 feet] 14.3 m [47 feet] 12.5 m [41 feet] Table 3 continues... © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 24: Multi-Dryer Installation Exhaust Requirements
2. Clean Out Cover (Must be provided). Inspect monthly. 3. Weather Hood or Sweep Elbow (No cap or screen) 4. 610 mm [24 in.] Minimum Clearance to Roof/Ground Figure 16 © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... - Page 25 305 mm [12 inches] 326 mm [13 inches] 356 mm [14 inches] 381 mm [15 inches] 381 mm [15 inches] 406 mm [16 inches] Table 4 © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT...
-
Page 26: Position And Level The Unit
Position and Level the Unit Dryer Rear 102 mm [4 in.] Exhaust Duct 51 mm [2 in.] Clearance to Combustible Ma- terials Table continues... © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 27: Wipe Out Inside Of Washer And Dryer Drums
8. Remove rubber feet from accessories bag and place on all cloth to remove shipping dust from inside the drums. four leveling legs. 9. Verify that unit doesn’t rock. SWD1012N_SVG Figure 20 © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 28: Connect The Washer To Electrical Power
DO NOT use an extension cord. • DO NOT use an adapter. • DO NOT operate both a washer and a gas dryer on the same circuit. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 29: Connect The Dryer To Electrical Power
W888 Electric Models SINGLE-PHASE MODELS 230 Volt, 50 Hertz, 2 Wire Plus Earth/Ground, 30 Amp In- stallation THREE-PHASE MODELS © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 30: Earth/Ground And Wiring Instructions
2. Run washer with a test load to make sure it is operating prop- erly and properly leveled. W158 © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... - Page 31 3. Air Shutter Lockscrew 4. Air Shutter 5. 3.1 mm [1/8 in.] Pipe Plug (For checking manifold pres- sure) 6. Open Position Figure 24 © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT...
-
Page 32: Operation
NOTE: Different fabrics will have different densities and loads must be adjusted accordingly to meet ma- chine loading specifications shown. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 33: Determine Proper Controls
Push touchpad for desired cycle. Light indicates selection. NORMAL 90 FLW82R_SVG NORMAL 60 W388I_SVG Figure 29 FLW83R_SVG Start Washer NORMAL 40 Push the START pad. FLW84R_SVG Table continues... © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 34: Indicator Lights
NOTE: Once a cycle has started, the door can only be opened by first unplugging the power cord and waiting one minute. D608I_SVG Figure 31 © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 35: Load Laundry
2. Check pricing as seen on digital display. SWD1032N_SVG Figure 33 Determine Proper Controls The direction of the arrow indicates which control is for which unit. W388I_SVG Figure 35 © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 36: Start Dryer
COOL DOWN portion of a Remove laundry immediately after dryer stops. heated cycle is active. It is also lit when the NO HEAT cycle is in operation. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 37: Maintenance
Cleaning Glass Sealing Area In order to assure that the door properly seals against water leaks, the following surfaces should be wiped off periodically: © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 38: Care Of Your Dryer
W043 1. Lint Filter Figure 38 Reinstallation of Shipping Materials To prevent damage while moving the unit, the shipping materials MUST be reinstalled. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 39: Motor Overload Protector
Dryer can be restarted by pressing the START pad. If overload protector cycles again, remove the dryer from use and call the service person to correct the problem. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 40: Troubleshooting
Refer to the Installation instructions to make sure that the drain hose has been proper- ly installed. • Foreign object trap in pump may be clogged. Clean the trap. Refer to Maintenance section. Table continues... © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... - Page 41 “H” on the valve bracket) and cold faucet is connected to cold mixing valve (indicated with “C” on the valve bracket). • Make sure laundry room water heater is adjusted properly. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT...
- Page 42 Normal operating sounds include the heat source going on and off and the humming of air moving through the dryer and exhaust system. Table continues... © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT...
- Page 43 • Ventilate room before drying clothes. © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT...
-
Page 44: Disposal Of Unit
MIX1N_SVG Figure 41 © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 45: Contact Information
Serial Number _______________________________ Please include a copy of your bill of sale and any service receipts you have. DRY2527N_SVG 1. Serial Plate Figure 42 © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT... -
Page 48: Installer Checklist
Start and Run Dryer in Heat Setting to Verify Dryer is Heating. • Connect Gas Supply Pipe. • Check for Gas Leaks. D233I_SVG1 CHECK CHECK Refer to the manual for more detailed information © Published by permission of the copyright owner - Part No. 805898ENR1 DO NOT COPY or TRANSMIT...
Need help?
Do you have a question about the 805898ENR1 and is the answer not in the manual?
Questions and answers