Table of Contents
Advertisement
Hot Restart
To start an engine that is already warmed up (hot restart),
or if the ambient temperature exceeds 68 F (20 C):
1. Pump the primer bulb at the bottom of the carburetor
until fuel can be seen flowing through the fuel return
line to the fuel tank (Figs. 9).
2. Move the choke lever to the open (
move the stop switch to the "ON" position (Figs. 10
and 11).
3. Leave the throttle trigger in the idle position and pull
the starter handle (Figs. 11 and 10).
4. If the engine fails to start after three to four pulls,
follow the instructions in the Cold Starting Procedure
section above.
If the engine fails to start after you follow the above
procedures, contact an authorized Toro dealer.
To Stop The Engine:
1. Release the throttle trigger (Fig. 11).
2. Slide the stop switch to the "STOP" position (Fig. 11).
Operation
POTENTIAL HAZARD
Foreign objects can be thrown by Brushcutter.
WHAT CAN HAPPEN
Contact with thrown objects can cause personal
injury.
HOW TO AVOID THE HAZARD
Never operate the Brushcutter without the
blade shield in place.
Read the Safety instructions on page NO TAG
concerning proper use of the Brushcutter.
Operating Position
Before using the Brushcutter, check the following:
1. Make sure the 3mm hex wrench has been removed
from the gearcase and boss adapter before you start the
engine (Fig 6).
2. The operator must be wearing the strap attached to the
Brushcutter, and the Brushcutter must be on the
operator's right side.
3. The operator's right hand should be holding the
right-hand bullhorn grip, with his or her fingers on the
) position and
throttle trigger.
4. The left hand should be holding the left-hand bullhorn
grip with the fingers and thumb fully enclosed around
the grip.
5. Always release the throttle trigger and allow the
engine to return to idle speed when not cutting.
6. Stop the Brushcutter engine when moving between
work sites.
POTENTIAL HAZARD
WHAT CAN HAPPEN
HOW TO AVOID THE HAZARD
If the Brushcutter blade becomes jammed, stop the
engine immediately.
Make certain all moving parts have stopped and
disconnect the spark plug before inspecting the
equipment for damage.
Never use a Brushcutter that has chipped, cracked or
broken blade or blade shield.
12
Without the strap installed, the Brushcutter
blade can produce side thrust which can expose
the operator and bystanders to blade contact.
If the Brushcutter is not correctly positioned on
the operator's right side, the blade can produce
side thrust which can expose the operator and
bystanders to blade contact.
Contact with the Brushcutter blade can cause
severe personal injury.
Never operate the Brushcutter without
installing and using the strap.
Always operate the Brushcutter with the unit
on your right side.
Always wear gloves and protective clothing
when operating the Brushcutter.
Advertisement
Table of Contents
