2. After adjusting height-of-cut, remove bolt and nut
(Fig. 25).
3. Select hole so gage wheel is positioned to the nearest
corresponding height-of-cut desired (Fig. 25).
Note: Do not adjust rollers to support the deck.
4. Reinstall the bolt, center rollers and nut (Fig. 25).
3
1
Figure 25
1. Center rollers and spacer
2. Nut
Positioning the Seat
The seat can move forward and backward. Position the
seat where you have the best control of the machine and
are most comfortable.
1. To adjust, move the lever sideways to unlock seat
(Fig. 26).
2. Slide the seat to the desired position and release lever
to lock in position.
2
m–4124
3. Bolt
23
1
Figure 26
1. Adjustment lever
Pushing the Machine by Hand
Important
Always push the machine by hand. Never
tow the machine because hydraulic damage may occur.
To Push the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to off to stop the engine.
2. Rotate the by-pass valves counterclockwise 1 turn to
push. This allows hydraulic fluid to by-pass the pump
enabling the wheels to turn (Fig. 27).
Important
Do not rotate by-pass valves more than 1
turn. This prevents valves from coming out of the body
and causing fluid to run out.
To Operate the Machine
1. Turn the by-pass valves in to operate (Fig. 27).
Note: The machine will not drive unless by-pass valves
are turned in.
m–3655