Servicing The Gear Box; Adjusting The Electric Clutch - Toro 74264TE Operator's Manual

3. Remove the dust cap from caster and tighten lock
nut (Figure 50).
4. Tighten the locknut until the spring washers are flat
and then back off a 1/4 turn to properly set the
pre-load on the bearings (Figure 50).
Important: Make sure spring washers are
installed correctly as shown in Figure 50.
5. Install the dust cap (Figure 50).
1. Spring Washers
2. Lock Nut

Servicing the Gear Box

Checking the Gear Box Oil Level
Service Interval: Every 100 hours
Use SAE 75W–90 Synthetic Gear Lube.
1. Park the machine on a level surface.
2. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
3. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
4. Remove the side or rear plug on the gear box.
(Figure 51).
5. The oil should be up to the opening of the gear box.
6. Add oil if needed to bring it to the correct level.
Figure 50
3. Dust Cap
1. Gear box
2. Side plug
Changing the Gear Box Oil
Service Interval: After the first 100 hours
Yearly
Contact an Authorized Service Dealer to change the
gear box oil.

Adjusting the Electric Clutch

Service Interval: Every 500 hours
The clutch is adjustable to ensure proper engagement
and proper braking.
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Unlatch the seat and tip it forward.
4. Loosen the front engine panel knobs and remove
the panel.
5. Pull up on the spring loaded idler pulley for the PTO
drive belt and remove the belt from the clutch pulley
(Figure 52).
41
Figure 51
3. Rear plug
4. Pulley