Folding The Handle - Toro Recycler 20372 Operator's Manual

3. Lower the machine to its lowest cutting-height setting.
Refer to Adjusting the Cutting Height (page
4. Wash out the area under the rear deflector where the
clippings go from the housing to the grass bag.
Note: Wash out the area with the bag-on-demand in
both the fully forward and fully rearward positions.
5. Attach a garden hose that is connected to a water
supply to the washout port on the machine
1. Washout port
6. Turn the water on.
7. Start the engine and run it until there are no more
clippings that come out from under the machine.
8. Stop the engine.
9. Shut off the water and disconnect the garden hose
from the machine.
10. Start the engine and run it for a few minutes to dry the
underside of the machine to prevent it from rusting.
11. Allow the engine to cool before storing the machine
in an enclosed area.

Folding the Handle

WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the electric-start button
(Figure
G017312
Figure 25
(Figure 26).
10).
25).
1. Electric starter
2. Remove and save the 2 handle knobs and 2 carriage
bolts from the handle brackets
Important: Route the cables to the outside of the
handle knobs as you fold the handle.
1. Handle knob
3. Fold the handle by rotating it forward
15
Figure 26
2. Electric-start button
(Figure 27).
Figure 27
2. Carriage bolt
(Figure 28).