Toro 30529 Operator's Manual page 39

Problem
The cutting height is uneven. g g
The blades do not rotate.
The blades do not stop when they
are disengaged. g g
Possible Causes
1. The blades are not sharp.
2. The blades are bent.
3. The mower is not level.
4. The underside of the mower
is dirty.
5. The tire pressure is incorrect.
6. The blade spindle is bent.
1. The drive belt is worn, loose,
or broken.
2. The drive belt is off the pulley.
3. The mower belt is worn,
loose, or broken.
4. The mower belt is off the
pulley.
1. The blade brake is not
adjusted properly.
2. The belt guide is not set
properly.
39
Corrective Action
1. Sharpen the blades.
2. Install new blades.
3. Level the mower from
side-to-side and front-to-rear.
4. Clean the underside of the
mower.
5. Adjust the tire pressure.
6. Contact an Authorized
Service Dealer.
1. Check the belt tension.
2. Install the drive belt and
check the adjusting shafts
and the belt guides for the
correct position.
3. Install the new mower belt.
4. Install the deck pulley and
check the idler pulley, idler
arm, and spring for the
correct position and function.
1. Adjust the blade brake.
2. Adjust the belt guide.