Position C
This is the full open position. The suggested use for this
position is as follows.
• Use in tall, dense grass mowing conditions.
• Use in wet conditions.
• Lowers the engine power consumption.
• Allows increased ground speed in heavy conditions.
• This position is similar to the benefits of the Toro SFS
mower.
Full Forward Position
Figure 24
Positioning the Seat
The seat can move forward and backward. Position the
seat where you have the best control of the machine and
are most comfortable.
1. To adjust, move the lever sideways to unlock the seat
(Fig. 25).
2. Slide the seat to the desired position and release the
lever to lock it in position.
1
Figure 25
1. Adjustment lever
m–6827
m–3655
24
Unlatching the Seat
Push the seat latch rearward to unlatch the seat. This will
allow access to the machine under the seat.
2
1
Figure 26
1. Seat latch
2. Gas cap
Pushing the Machine by Hand
Important
Always push the machine by hand. Never
tow the machine because hydraulic damage may occur.
Pushing the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to off. Move levers to neutral locked
position and apply parking brake. Remove the key.
2. Rotate the by-pass valves counterclockwise 1 turn to
push. This allows hydraulic fluid to by-pass the pump
enabling the wheels to turn (Fig. 27).
Important
Do not rotate by-pass valves more than
1 turn. This prevents valves from coming out of the body
and causing fluid to run out.
3. Disengage parking brake before pushing.
Changing to Machine Operation
1. Rotate the by-pass valves clockwise 1 turn to operate
machine (Fig. 27).
Note: Do not over tighten the by–pass valves.
Note: The machine will not drive unless by-pass valves
are turned in.
3
m–6840
3. Seat