Table of Contents
Advertisement
g0151 16
Figure 17
•
Remove the debris from the housing vents along the top
of the mower.
•
Brush all the debris off the mower housing.
•
Inspect the power plug receptacle for signs of melting
or heating. Old worn-out extension cord plugs that fit
loosely in the plug receptacle can cause overheating from
poor contact. Replace any damaged extension cords
immediately (if applicable) .
Lubricating the Machine
Lubricate the wheels, linkages, and pivot points every 25
operating hours with engine oil (Figure 18).
g0151 15
Figure 18
Servicing the Blade
Always mow with a sharp blade. A sharp blade cuts the grass
evenly, without tearing or shredding the grass.
When you replace the blade, use only genuine Toro
replacement blades.
WARNING
Someone could accidentally start the motor
and cause a serious injury to the operator or to
bystanders.
Do not attempt to inspect, remove, or replace the
blade without first disconnecting the mower from
the power source.
1. Stop the motor and wait for all moving parts to stop.
2. Disconnect the mower from the electrical power
source.
3. Tip the mower onto its side.
4. Carefully examine the blade for sharpness and wear,
especially where the flat and curved parts of the blade
meet. If you notice wear, replace the blade.
Note: For best performance, install a new blade
before the mowing season begins. During the season,
file down small nicks on the blade to maintain its
cutting edge.
DANGER
A worn or damaged blade could break and a
piece of blade could be thrown in the operator's
or bystander's direction, causing serious personal
injury or death.
Inspect the blade periodically for wear or damage,
and replace a worn or damaged blade.
Removing the Blade
1. Grasp the end of the blade (Figure 19) with a rag or
thickly padded glove.
1. Blade bolt
2. Remove the blade bolt and the blade.
Important: If the blade adapter comes off, ensure
that you install it before installing the blade and
10
2
1
Figure 19
2. Blade
g014059
Advertisement
Table of Contents
