Operation - LG LW2414HR Service Manual

Installation

Operation

• VENTILATION
The ventilation lever must be in the CLOSE position in
order to maintain the best cooling conditions.
When a fresh air is necessary in the room, set the ven-
tilation lever to the OPEN position.
The damper is opened and room air is exhausted.
2
7
4
1. POWER BUTTON
To turn the air conditioner ON, push the button. To turn the air conditioner OFF, push the button again.
This button takes priority over any other buttons.
2. OPERATION MODE SELECTION BUTTON
Everytime you push this button, it will toggle COOL, FAN and HEAT.
3. ON/OFF TIMER BUTTON
Everytime you push this button, timer is set as follows.(1Hour
7Hours 8Hours 9Hours
4. FAN SPEED SELECTOR
Everytime you push this button, it is set as follows. (Hi[
5. ROOM TEMPERATURE SETTING BUTTON
This button can automatically control the temperature of the room. The temperature can be set within a range of 60°F to
86°F by 1°F.
6. AUTO SWING
This button can automatically control the air flow direction.
7. ENERGY SAVER
The fan stops when the compressor stops cooling.
Approximately every 3 munutes the fan will turn on and check the room air to determine if cooling is needed.
8. REMOCON SIGNAL RECEIVER
CAUTION: A slight heat odor may come from the unit when first switching to
HEAT after the cooling season is over. This odor, caused by fine dust particles on
the heater, will disappear quickly.
13 Room Air Conditioner
3
5 6
10Hours 11Hours
CLOSE
REMOTE CONTROLLER
8
5
1
3
7
2Hours 3Hours
12Hours Cancel)
] Low[ ] Hi[
VENT OPEN
Power
1
Temp
Fan Speed
4
Timer Mode
2
Energy Auto
Saver Swing
6
4Hours 5Hours 6Hours
]....)