Table of Contents
Advertisement
2. Disengage the blades (PTO).
3. Turn the ignition key to the Off position.
4. Set the parking brake if you leave the machine
unattended; refer to Setting the Parking Brake.
Note: Remove the keys from the ignition and KeyChoice
switches.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition and KeyChoice keys
and set the parking brake when leaving the machine
unattended, even if it is just for a few minutes.
Using the Recycle on Demand
You can activate or deactivate the recycle-on-demand feature
while the machine is mowing or is stopped. If you are bagging
grass that is tall and thick, raise the height-of-cut and mow
at a slower speed.
1. Move the recycle-on-demand lever (Figure 4) forward
to collect the grass clippings.
2. Move the recycle-on-demand lever rearward to stop
collecting the grass clippings and recycle them.
Emptying the Grass Collector
When the grass collector is full, a buzzer sounds and the grass
collector must be emptied.
Important: To prevent the discharge tunnel from
getting clogged, disengage the blades (PTO) when the
buzzer sounds.
1. Disengage the locking latch (Figure 15).
1. Locking latch
G017876
Figure 15
2. Disengage the blades (PTO) and move the throttle to
the Slow position.
3. Pull the grass collector dump lever forward and tilt the
grass collector (Figure 16).
1. Grass collector dump lever
4. Empty the grass collector.
5. Before returning the grass collector to the operating
position, move the machine forward to clear the grass
collector of the deposited grass.
6. Slowly lower the telescoping dump lever to return the
grass collector to the operating position.
Rear-discharging the Grass
Clippings
Occasionally, you may need to cut the lawn without the grass
collector when the grass is too long for collecting.
1. Disengage the locking latch (Figure 17).
1
16
1
Figure 16
G017877
Advertisement
Table of Contents
