Loose Parts; Installing The Handle; Installing The Discharge Chute - Toro CCR Powerlite 38182 Operator's Manual

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Step
1.
2.

1. Installing the Handle

1. Position the ends of the upper handle on the inside of
the lower handle and align the holes.
2. Insert the oval-head bolts into the aligned holes, with
the bolt heads on the outside of the handle. (Figure 3).
Figure 3
3. Install the curved washers and the handle knobs on the
oval-head bolts and tighten the knobs securely.
Description
Oval-head bolts
Curved washers
Handle knobs
Discharge chute
Washers
Locknuts
Knob
Qty.
2
2 Install the handle.
2
1
2
Install the discharge chute.
2
1
2. Installing the Discharge
Chute
1. Position the holes in the sides of the discharge chute
over the bolts ends on the sides of the chute handle.
(Figure 4).
Figure 4
1. Discharge chute
2. Bolt ends
2. Secure the sides of the discharge chute with 2 washers
and 2 locknuts.
3. Rotate the discharge chute to the upright position.
4. Install the knob tightly onto the bolt end at the rear of
the discharge chute.
5
Use
3. Knob