Black & Decker FSWM1000 Instruction Manual page 4

FSWM1000 8/24/06 9:25 AM
2. Reach through the openings in the table
top and grasp the lower section of the
bench. Pull up on the lower section to begin
collapsing the legs. (figure G)
3. Lower the unit to the ground as shown in
figure H.
4. Once the unit is flat on the ground, press
down on the table top to place the unit into
its fully closed position as shown in figure I.
ADJUSTABLE CLAMPS
The two adjustable clamps can be used in both a vertical and horizontal mode. The long
channels in the table top allow the clamps to be anchored in a stationary horizontal
position. The shorter slots in the table top allow for the clamps to be used in a vertical
position. (figure J). J1 through J6 illustrate how to use the clamps in both horizontal and
vertical modes.
J1 - To expand the opening of the clamp jaws, press in on the release lever and move the
jaw as shown. The jaw that is attached to the handle can also be moved in the same
manner or by squeezing and releasing the front handle.
J2 - Line up the round post on the end of the clamp bar with the mating openings on both
sides of the main slot in the tabletop as shown.
J3 - To lock the clamp in a horizontal position, squeeze the front handle and line up the
round protruding tabs with the mating openings in the tabletop (behind the openings
mentioned in J2 above).
Page 4
G
H
I
4