Cleaning The Mower; Preparing The Mower For Storage - Toro 20053 Operator's Manual

Figure 33
4. Remove the blade, saving all mounting hardware.
5. Install the new blade and all mounting hardware.
Important: Position the curved ends of the blade
to point toward the mower housing.
6. Use a torque wrench to tighten the blade bolt to
60 ft-lb (82 N⋅m).
Important: A bolt torqued to 60 ft-lb (82 N⋅m)
is very tight. While holding the blade with a block
of wood, put your weight behind the ratchet or
wrench and tighten the bolt securely. This bolt is
very difficult to overtighten.

Cleaning the Mower

The mower may dislodge material from under the
mower housing.
•
Wear eye protection.
•
Stay in the operating position (behind the
handle) when the engine is running.
•
Do not allow bystanders in the area.
For best results, clean the mower soon after you have
completed mowing.
1. Lower the mower to its lowest cutting height setting.
Refer to Adjusting the Cutting Height.
2. Move the mower onto a flat paved surface.
3. Attach a garden hose that is connected to a water supply
to the washout port on the mower housing (Figure 34).
Figure 34
1. Washout port
4. Turn the water on.
5. Start the engine and run it until there are no more
clippings that come out from under the mower housing.
6. Stop the engine.
7. Shut off the water and disconnect the garden hose from
the mower.
8. Start the engine and run it for a few minutes to dry the
housing.
Storage
Store the mower in a cool, clean, dry place.
Preparing the Mower for
Storage
Gasoline vapors can explode.
•
Do not store gasoline more than 30 days.
•
Do not store the mower in an enclosure near an
open flame.
•
Allow the engine to cool before storing it.
1. On the last refueling of the year, add fuel stabilizer to
the fuel as directed by the engine manufacturer.
2. Run the mower until the engine stops from running
out of fuel.
3. Prime the engine and start it again.
12