Using The Grass Bag - Toro 26634 Operator's Manual

Using the Grass Bag

Installing the Grass Bag
1. Wait for all moving parts to stop.
2. Raise the discharge door, slide the bag ramp attached to
the grass bag into the discharge opening, and hook the
bag frame onto the rounded portion of the mounting
brackets (Fig. 13).
3
1
6
4
2
Figure 13
1. Bag door
2. Bag ramp
3. Discharge door
Note: Ensure that the grass bag door is fully closed against
the grass bag before installing the bag.
3. Allow the discharge door to close on top of the grass
bag (Fig. 14).
Figure 14
5
775
4. Bag handle
5. Mounting bracket (2)
6. Bag frame hook (2)
795
10
Mowing with the Grass Bag
Warning
A worn grass bag could allow small stones and
other similar debris to be thrown in the operator's
or bystander's direction and result in serious
personal injury or death to the operator or
bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
Cut the grass until the bag is full.
Important Do not overfill the bag.
Removing the Grass Bag
1. Stop the engine and wait for all moving parts to stop.
2. Raise the discharge door and hold it up.
3. Grasp the handle on the grass bag and lift it off of the
lawn mower.
4. Close the discharge door.
Note: When removing the grass bag, the bag ramp removes
any clippings that may plug the discharge opening. If the
discharge opening is still plugged, disconnect the wire from
the spark plug and remove the clippings with a stick.
Danger
If the discharge door does not close completely, the
lawn mower could throw objects, causing serious
personal injury or death.
If you cannot close the discharge door because the
grass clippings clog the discharge area, stop the
engine, wait for all moving parts to stop, and
gently move the discharge door handle back and
forth until you can close the discharge door
completely. If you still cannot close the discharge
door, remove the obstruction with a stick, not your
hand.