Filling The Crankcase With Oil - Toro 22178TE Operator's Manual

2
Installing the Fuel Tank and
the Fuel Line
Parts needed for this procedure:
2 Self-tapping screw
1
Procedure
1. Slide the end of the fuel line onto the elbow fitting
(Figure 4).
1
2
3
4
1. Fuel tank
2. Elbow fitting
2. Secure the fuel line in place with the fuel line clamp
(Figure 4).
3. Slide the plastic clips on the front of the fuel tank
onto the fuel tank mount (Figure 5).
G002527
Figure 4
3. Fuel line
4. Fuel line clamp
1. Plastic clip (2)
4. Secure the bottom of the fuel tank to the fuel tank
bracket by installing the self-tapping screws from the
bottom. Do not overtighten the screws.
3

Filling the Crankcase with Oil

No Parts Required
Procedure
The engine crankcase is shipped without oil. You must
fill it with approximately 29 oz. (0.85 l) of oil before
starting the engine. Refer to Checking the Engine Oil
Level in Operation , page 10 for oil specifications and
instructions.
8
Figure 5