Unlatching The Seat; Pushing The Machine By Hand - Toro Z580-D Z Master 74266CP Operator's Manual

Changing the Seat Suspension
The seat can be adjusted to provide a smooth and
comfortable ride. Position the seat where you are most
comfortable.
To adjust it, turn the knob in front either direction to
provide the best comfort (Figure 24).
Changing the Back Position
The back of the seat can be adjusted to provide a
comfortable ride. Position the back of the seat where it
is most comfortable.
To adjust it, turn the knob, under the right-side arm
rest, in either direction to provide the best comfort
(Figure 25).
Figure 25
1. Back rest knob

Unlatching the Seat

Push the seat latch rearward to unlatch the seat.
This will allow access to the machine under the seat
(Figure 26).
2. Right-side arm rest
1. Seat latch
2. Fuel cap

Pushing the Machine by Hand

Important: Always push the machine by hand.
Never tow the machine because hydraulic damage
may occur.
Pushing the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to off. Move the levers to neutral locked
position and apply parking brake. Remove the key.
2. Rotate the by-pass valves counterclockwise 1 turn
to push. This allows hydraulic fluid to by-pass the
pump enabling the wheels to turn (Figure 27).
Important: Do not rotate by-pass valves more
than 1 turn. This prevents valves from coming
out of the body and causing fluid to run out.
3. Disengage parking brake before pushing.
Changing to Machine Operation
Rotate the by-pass valves clockwise 1 turn to operate
machine (Figure 27).
Note: Do not over tighten the by-pass valves.
The machine will not drive unless by-pass valves are
turned in.
25
Figure 26
3. Seat