Module, Keychoice™ Reverse Operating System (Manual Pto Clutch) - Toro 315-8 User Manual

Table of Contents

Advertisement

Module, KeyChoice™ Reverse
Operating System (Manual PTO
Clutch)
Purpose
The Key Choice™ Reverse Operating System module
works with the KeyChoice™ switch, PTO switch, and
the reverse switch. It responds to the reverse switch; if
the override switch (KeyChoice™ switch) is not
activated and the PTO is engaged, it will stop the
engine (Figure 13).
Figure 13
How it Works
The Key Choice™ Reverse Operating System is made
up of several components, such as diodes and relays.
When it is connected in the circuit, voltage is applied to
certain terminals of the Key Choice™ Reverse
Operating System module from the PTO switch,
reverse switch, and the override switch, which
energizes certain relays in the module. If voltage is not
applied to the proper terminals on the Key Choice™
Reverse Operating System module, the engine will
stop.
Demystification Glossary
Testing
The Key Choice™ Reverse Operating System module
must be removed from the circuit. Using a multimeter
check the following:
Meter
Meter
Probe
Scale
Negative
Ohms Pin 3
Ohms Pin 3
Diode
Pin 3
Diode
Pin 3
Ohms Pin 3
* NOTE: If multimeter does not have a diode scale,
this test can not be done. This is not a problem if
powered tests are done. Powered test must be done to
check out relays (Figure 14).
mvc-692
Powered circuit test (with module out of circuit). A
12 volt battery is needed for this test. NOTE: USE
CAUTION WHEN MEASURING RESISTANCE WITH
A POWERED CIRCUIT. CONTACTING A VOLTAGE
SOURCE WITH METER IN OHMS POSITION CAN
SERIOUSLY DAMAGE THE METER.
B+
Ground
(12V)
Pin 3
Pin 4 Pin 3
Pin 3
Pin 5 Pin 3
Pin 3
Pin 2 Pin 3
Pin 3
Pin 2 Pin 3
** NOTE: Actual reading should be same as B+
applied to Pin 2.
GLOSSARY
Meter
Probe
Meter Reading
Positive
Pin 1
Open (more than
100k ohm)
Pin 2
350 to 450 ohms
Pin 4
0.7V to 1.0V *
Pin 5
0.7V to 1.0V *
Pin 6
Open (more than
100k ohms)
Figure 14
Meter
Meter
Meter
Probe
Probe
Scale
Neg.
Pos.
Pin 1
Ohms
<2 ohms
Pin 1
Ohms
<2 ohms
Pin 1
Ohms
<2 ohms
Pin 6
Volts
12 V **
Meter
Reading
3 - 13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents