Table of Contents
Advertisement
c. Place grass catcher on the pivot rod. Let go
of discharge door so that it rests on the grass
catcher. See Figure 3-5.
To remove the grass catcher, lift the rear discharge door
on the mower. Lift the grass catcher up, off of the pivot
rod. Release the rear discharge door.
5. To convert to side discharge, make sure grass catcher
is off of the unit. Replace the rear mulching baffle and
close rear discharge door. To discharge grass to the
side:
a. Lift mulching plug on the right side of mower.
b. Slide two hooks of side discharge chute under
the hinge pin on the mulching plug assembly and
lower the side mulching plug. See Figure 3-6.
NOTE: Do not remove the side mulching plug at any time,
even when you are not mulching.
WARNING: Never operate mower unless
the hooks on the grass catcher are
firmly seated on the pivot rod and the
rear discharge door rests firmly against
top of the grass catcher.
Adjustments
1. The cutting height adjustment lever is located above
the rear left wheel. See Figure 3-7.
a. Pull the lever out and away from the mower.
b. Move the lever forward or back for desired cutting
height.
c. Release lever towards mower deck.
WARNING: Do not at any time make any
adjustment to lawn mower without first
stopping motor and removing key.
Figure 3-5: Attach the grass catcher.
Figure 3-6: Converting to side discharge.
Figure 3-7: Use adjustment levers to change height.
Setup and
Adjustment
WARNING
Never operate mower
unless the hooks on
the grass catcher are
firmly seated on the
A
pivot rod and the rear
discharge door rests
firmly against top of
the grass catcher.
B
Do not at any time
ment to lawn mower
without first stopping
motor and removing
B
A
C
3
make any adjust-
key.
Advertisement
Table of Contents
