Toro Z441 Z Master 74441 Operator's Manual page 42

5. Move lever to the neutral position but not
locked (Figure 53).
Figure 53
1. Neutral locked position
2. Control lever
6. Pull the lever back until the clevis pin (on the
arm below the pivot shaft) contacts the end
of the slot (just beginning to put pressure on
the spring) (Figure 54).
3. Neutral position
Figure 54
1. Clevis pin in slot
2. Nut
3. Nut-Left hand thread
4. Adjustment bolt
5. Pump rod
7. Check where the control lever is relative to the
notch in the console (Figure 53). It should be
centered, allowing the lever to pivot outward
to the neutral lock position.
8. If adjustment is needed, loosen the nut and
jam nut against the yoke (Figure 54).
9. Apply slight rearward pressure on the motion
control lever, and turn the head of the
adjustment bolt in the appropriate direction
until the control lever is centered in the neutral
lock position.
Note: Keeping rearward pressure on the
lever will keep the pin at the end of the slot and
allow the adjustment bolt to move the lever to
the appropriate position.
10. Tighten the nut and jam nut (Figure 54).
11. Repeat on the opposite side of machine.
42
6. Double nuts
7. Jam nut
8. Yoke
9. Ball joint