Toro Power Plus P216V Service Manual page 37

FLYWHEEL
Removing the flywheel is a relatively simple process, but
the following procedure must be followed to avoid
damage to the gear case and possible injury to the
1. Turn the flywheel mounting screw outward about
two turns.
Incorrect flywheel removal can
result in severe personal injury.
Do not remove flywheel screw completely when
using flywheel puller.
2. Install a flywheel puller on the flywheel (Figure 8).
FLYWHEEL
FLYWHEEL
MOUNTING SCREW
CS-1000
FIGURE
8.
FLYWHEEL PULLER
3. Turn the puller bolts in, alternately, until the wheel
snaps loose on the shaft.
Improper flywheel removal can
cause gear case damage. Do not
use any tools to pry against gear cover when
removing flywheel.
4.
Unscrew the puller from the flywheel, remove the
flywheel mounting screw and washer and pull the
flywheel off the shaft. Take care not to drop the
wheel. A bent or broken fin will destroy the balance.
GEAR COVER
After removing the mounting screws, tap the gear cover
gently with a soft faced hammer to loosen
it.
When installing the gear cover, make sure the pin in the
gear cover engages the nylon lined (smooth) hole in the
governor cup. Turn the governor cup so the nylon lined,
hole is at the three o'clock position. Use a small amount
of grease to assist in holding governor cup in position.
The smooth side of the governor yoke must ride against
the governor cup. Turn the governor arm and shaft
clockwise as far as possible and hold in this position
until the gear cover is installed flush against the
crankcase.
Be
careful not to damage the gear cover oil
seal (Figure 9).
ROLL PIN
CUP SO ROLL PIN FITS
INTO THE METAL LINED
HOLE OR PLASTIC
BUSHING
IN
THE CUP
ROTATE GOVERNOR
GOVERNOR SHAFT
GOVERNOR SHAFT
YOKE (Smooth Side
Toward
Cup)
OIL SEAL
I
GOVERNOR CUP
GOVERNOR
IF FEELER WILL
ENTER HOLE
FALLEN OUT
FIGURE 9. GEAR COVER ASSEMBLY