Adjusting The Cutting Height; Using The Grass Bag - Toro 22187 Operator's Manual

Adjusting the Cutting
Height
Each wheel is adjusted individually with a wheel
height adjustment lever. Cutting heights are 1 inch
(25 mm), 1-1/2 inches (38 mm), 2 inches (51 mm),
2-1/2 inches (64 mm), 3 inches (76 mm), and
3-1/2 inches (89 mm).
Adjusting the cutting height levers could
bring your hands into contact with a moving
blade and result in serious injury.
• Stop the engine and wait for all
movement to stop before adjusting the
cutting height.
• Do not put your fingers under the
housing when adjusting the cutting
height.
1. Pull the wheel height adjustment lever toward
the wheel (Figure 17) and move it to the
desired setting.
Figure 17
1. Wheel height adjustment lever
2. Release the wheel height adjustment lever and
seat it securely in the notch.
3. Adjust all the wheels to the same cutting height
setting.

Using the Grass Bag

Occasionally, you may wish to use the grass bag
for bagging extra long grass, lush grass, or leaves.
Installing the Grass Bag
1. Stop the engine and wait for all moving parts
to stop.
2. Ensure that the discharge door handle is fully
forward and that the pin is engaged in the
catch (Figure 18).
Figure 18
1. Bag frame on retaining
post
2. Pin engaged in catch
3. Slide the hole in the bag frame onto the
retaining post on the discharge tunnel
(Figure 18).
4. Set the rear of the bag frame onto the bag
support rod.
5. Pull the discharge door handle forward until
the pin clears the catch, and move the handle
rearward until the pin locks in the bag notch
(Figure 19).
Figure 19
1. Pin locked in bag notch
Note: The discharge door in the lawn mower
housing is now open.
16
3. Handle fully forward;
discharge door closed