Table of Contents
Advertisement
4
Setup and
Adjustment
NOTE: References to
right or left side of the
mower is determined
from behind the unit in
the operating position.
IMPORTANT
Be certain to charge
the battery for at least
14 hours before operat-
ing your mower. Refer
to Operation section.
Figure 4-1
Figure 4-2
A
C
B
Figure 4-3
1. Remove any packing material which may be between
upper and lower handles.
a. Loosen each hand knob found on the inside of the
upper handle.
b. Gently lift and pivot the upper handle into the
operating position as shown in Figure 4-1.
c. Remove star knobs from handle mounting brackets
and secure the lower handle onto the handle
brackets by placing the lower hole of the lower
handle onto the pins of the handle brackets.
d. Secure the upper handle and lower handle by
tightening the hand knobs. Each carriage bolt
must be seated properly into the square hole found
in the plastic connector.
2. Tighten star knobs securing lower handle to handle
brackets. See Figure 4-2. Make certain the lower
handle is seated securely into the handle mounting
brackets.
3.
Follow steps below to assemble the grass catcher
(if needed). Make certain bag is turned right side
out before assembling (warning label will be on the
outside).
a. Place bag over frame (black plastic side is the bot-
tom of bag.) Insert the hooks on the frame through
the holes in the side plastic channels of the bag.
See Figure 4-3.
b. Secure bag to frame by working the plastic chan-
nels on bag over frame as shown in Figure 4-3.
c. All of the plastic channels except center top of bag
attach from the outside of bag. Center top of bag
attaches from the inside of bag.
4. Follow steps below to attach the grass catcher:
a. Lift rear discharge door. See Figure 4-4.
b. Remove rear mulching baffle.
c. Place grass catcher on the pivot rod. Let go
of discharge door so that it rests on the grass
catcher. See Figure 4-5.
Figure 4-4
8
A
B
Advertisement
Table of Contents
