Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for ATE MIG131L/1
- Page 1 INDUSTRIAL MIG131L/1 WELDER ASSEMBLY AND OPERATING INSTRUCTIONS...
- Page 2 MIG131L/1 Manual Specifications ITEM DESCRIPTION Welding Current 25—95A Duty Cycle 100%@25A 60%@35A 35%@50A 20%@75A Power Consumption 120VAC, 19amps at 60Hz Ground Cable 8AWG, single insulation , 6 foot Torch Power cable 8AWG, single insulation ,6 foot Power Cord 3-core, double insulated,14AWG...
- Page 3 9. Do not overreach. Keep proper footing and balance at all times .Do not reach over or across running machines. 10. Maintain tools with care . Keep tools sharp and clean for better and safer performance. Follow instructions for lubricating and changing accessories . Inspect tool cords periodically and, if damaged, have them repaired by an authorized technician.
- Page 4 This unit draws enough current to cause serious injury or death . Before turning the welder on , check the electrode holder to be sure that there are no protruding screw heads, and that all insulation is secure. Do not weld unless you are insulated form ground and the work piece. 2.
- Page 5 Assembly 1. Insert the Handle(12) into the Handle Sockets(11) and mount the Handle Sockets to the Side Panel B (1) top using supplied-hardware. 2. Lift Side Panel B(1) all the way to expose the wire spool and Wire Feed Mechanism(14). 3.
- Page 6 Operation Caution : Before arc welding, read and understand all safety precautions and warnings . 1. If using non-flux core wire, connect and secure the Argon/ CO gas hose to the rear of the MIG welder.( If using flux core wire, protective gas is not required.) 2.
- Page 7 Note: If too much current is drawn from the MIG Welder , the Thermal Overload protector will activate , the red Overload indicator will light, and the Arc Welder will turn off until cools down. If this happens, turn the ON/OFF Switch to the OFF position and wait about 3—5 minutes. 9.
- Page 8 Part List Item No. Description Item No. Description Upper side panel Power switch Rectifier Base frame Back panel Middle partition board Wire spool bolt Reactor Wire reel holder Transformer Wire spool Transformer carriage Adjusting spring Torch Washer Power cable Adjusting nut Ground cable Wire spool axle Handle socket...
- Page 9 Welder Assembly Drawings...
Need help?
Do you have a question about the MIG131L/1 and is the answer not in the manual?
Questions and answers