XVision XTM020 Instruction Manual

Site survey and test monitor

Table of Contents

Download this manual

TECHNICAL SUPPORT:

For Technical Support for any Xvision product please contact your local

distributor.

LIMITED WARRANTY:

This product is supplied with a limited 1 Year Warranty. The Warranty

excludes products that have been misused, (including accidental

damage) and damage caused by normal wear and tear. In the unlikely

event that you encounter a problem with this product, it should be

returned to the place of purchase.

Manufactured exclusively for:

Xvision (Europe) Group,

Head Office: London, U.K.

Email: info@x-vision.co.uk

Web: www.x-vision.co.uk

CCTV

Model:

Site Survey & Test

Monitor

Before you begin

•

Please unpack the box carefully and identify that all the parts are present.

Please bear in mind the following points when handling/using the monitor.

•

Avoid dropping or banging the monitor against another object, as this may cause damage.

•

Make sure you use only the recommended batteries or power supply. Damage caused to the

camera by incorrect voltage or wiring is not covered by the warranty.

Model:

XTM020

Site Survey & Test Monitor

XTM020

CCTV

Table of Contents

Do you have a question about the XTM020 and is the answer not in the manual?

Page 1 CCTV CCTV TECHNICAL SUPPORT: For Technical Support for any Xvision product please contact your local distributor. LIMITED WARRANTY: This product is supplied with a limited 1 Year Warranty. The Warranty excludes products that have been misused, (including accidental damage) and damage caused by normal wear and tear. In the unlikely...
Page 2 Resolution: 420TVL Lens Sizes: Built in 4, 6, 8, 12, & 16mm Infra Red Nightvision: Minimum Illumination: 0.5 Lux XTM020- Colour Leather Carry Case BNC to BNC Lead CCTV Test Monitor and Strap Electronic Shutter: 1/60 to 1/100,000 sec General...
Page 3 1. Connect the V OUT terminal to the Video Input of the device being tested Lens Angle Chart (Shows common lens angles) 2. Move the switch onthe front of the monitor to the V OUT position XTM020- Controls/Connections -Front Specification Model: XTM020 Test Monitor Screen Size: 3.5”...
Page 4 6mm view. (A table of angles available with input and built in monitor Xvision cameras is shown on the front of the monitor) • Allows one person to position a camera during commisioning Note: The camera fitted in the Test Monitor has a 1/3" sensor, so the •...