Table of Contents
Advertisement
OPERATING INSTRUCTIONS
Before plugging in check that the voltage matches that shown on the
rating label.
BEFORE USING
1.Make sure that all the packaging materials have been properly
removed before use.
2.Remove the excess water from hair with a towel, and comb it to
disentangle.
3.Before using the appliance, make sure the hair is slightly damp or dry.
Note: Never use this appliance to dry your hair, but only to
straighten it.
OPERATION
1.Connect the appliance to a wall socket and place it on dry surface and
resistant to heat.
2.Turn on the appliance by pressing for 1 second the on/off button, until
the default reading appear on the LCD display, and wait around 1-2
minutes for the appliance to reach the 150º C.
3.After reach the 150º C the appliance is ready to be used. The
temperature can be adjusted between 150 and 230º C. To raise the
temperature press the increase button (+) and to decrease it, press
the decrease button (-).
4.Note: for the majority of the normal hair, the temperature of 150º C is
sufficient for obtaining good results. However, if needed, the operating
temperature can be increased gradually up to 230º C.
5.The hair straightening should be made from the root to the ends. Hold
a small lock of hair, with approximately 50 mm of width and 5 mm of
thickness and place it between the plates. Close the plates and main-
taining some tension; gently slide them from the roots to the ends.
6.Note: the plates have very high temperatures during operation. Make
sure to keep them away from the scalp and skin to avoid burns.
7.Repeat this procedure all over the hair, allowing it to cool down before
combing or brushing.
8.When you finish, switch off the appliance on the the on/off button and
disconnect the plug from the wall socket.
STRAIGHTENER INSTRUCTIONS
7
Advertisement
Table of Contents
