Configuring Qos Inbound - Sangfor M5100 User Manual

3. Specify the following information.

Name, Description: Enter a name and description for the rule.

Priority: Select a priority level for the current rule. Apart from the four levels as listed on the QoS
Priority Level page, there is a Highest level, which means the corresponding service can occupy all the
bandwidth.

Enable rule: Select it to enable the current QoS outbound rule.

IP Address: Specify the source and destination IP addresses of the data packets applicable to this rule.
You can specify all or a specific IP address/range.

Protocol: Specify the protocol and ports of the services applicable to this rule.
4. Click the Save buttons to save the settings.
Configuring QoS Inbound Rule
QoS inbound rule enables administrator to set priority for specific data received through the WAN interface(s) of
the Sangfor device. You can set higher priority for data of critical business, so that they will be given more
bandwidth and be transmitted earlier and faster.
Navigate to Firewall > QoS Inbound Rule to enter QoS Inbound Rules page, as shown below:
SANGFOR SSL M6.8EN User Manual
314