LEDs). required. In the event of loss of power to the SP17 while it is N o t e : This unit has been shipped with the vacuum tubes turned on, the Power on/off switch will default to the “off”...
LED) until the “operate” position is manually selected. ably on solid, non-metal shelving. 2. Do not stack the SP17 on top of a power amplifier: not RESETTING CONTROLS: To avoid discharging static to the only could this cause overheating, but hum may be...
Input selector 1. Secure all rear-panel connections between SP17, power (tuner, aux, etc.) on the SP17. This signal will then be amplifier(s) and input sources. routed to the second tape deck when the appropriate input is selected by the Input selector switch.
Model SP17 C A U T I O N : Your SP17 contains sufficient levels of voltage Warranty Terms and Conditions and current to be lethal. Do not tamper with a Audio Research Corporation products are covered by a 3- component or part inside the unit.