Nektar impact LX 25 User Manual page 21

Assignment Types (E3)
Most of the controls in the default presets are assigned to MIDI CC messages. But there are several other options and the
below chart shows you which are available for the two types of controls.
Controller Type
Pitch bend, Modulation
Wheel, Fader, Pots 1-8
Transport buttons, Foot
Switch, Pads 1-8
To change an assignment type, do the following:

Press the E3 on your keyboard to select Control Assign. The display reads {ASG}

Press [Enter] (last C key on your keyboard) to confirm menu selection

Move or press a control. The type abbreviation you see in the display is the currently assigned type as per above chart

Change the value in decrements/increments using the keys with the -/+ symbols screened above (C3/C#3). The type
change is instant so if you exit the Setup menu after making changes, those changes remain active
Data 1 and Data 2 Values (C#3 & D#3)
The Data 1 and Data 2 functions are required for some controller assignments as per the chart below.
Controller Type
Pitch bend, Modulation
Wheel, Fader, Pots 1-8
Transport buttons, Foot
Switch,
To enter a Data 1 or Data 2 value, do the following:

Press either C#3 or D#3 on your keyboard to select either Data 1 or Data 2. The display reads {d1} or {d2}

Press [Enter] (last C key on your keyboard) to confirm menu selection.

Move or press a control. The controls Data 1 or Data 2 value will be visible in the display

Change the value in decrements/increments using the keys with the -/+ symbols screened above (C3/C#3). The value
assignment is instant so if you exit the Setup menu after making changes, those changes remain active

You can also enter a specific value using the white number keys spanning G3–B4. Press Enter (C5) to accept the change
www.nektartech.com
Assignment Type
MIDI CC
Pitch Bend
MIDI CC Toggle
MIDI CC Trigger/Release
MIDI note
MIDI note toggle
MIDI Machine Control
Assignment Type
MIDI CC
Pitch Bend
MIDI CC Toggle
MIDI CC Trigger/Release
MIDI note
MIDI Machine Control
Display Abbreviations
CC
Pbd
toG
trG
n
nt
nnc
Data 1 Data2
Max value Min value
Max value Min value
CC value 1 CC vaue 2
Trigger value Release value
Note on velocity MIDI note #
n/a Sub-ID #2
Nektar Impact LX25 User Guide 21