Olympus Stylus 840/ 840 Instruction Manual page 58

When you get an error message on the camera
Monitor indication
q
CARD ERROR
q
WRITE PROTECT
>
MEMORY FULL
q
CARD FULL
L
NO PICTURE
r
PICTURE ERROR
r
THE IMAGE
CANNOT BE
EDITED
CARD-COVER
OPEN
g
BATTERY EMPTY
CARD SETUP
CLEAN CARD CLEAN CARD
FORMAT
MEMORY SETUP
POWER OFF POWER OFF
MEMORY FORMAT
NO CONNECTION
58
NO PAPER
EN
Possible cause
There is a problem with the
card.
Writing to the card is
prohibited.
The internal memory has no
available memory and
cannot store any new data.
The card has no available
memory and cannot store
any new data.
There are no pictures in the
internal memory or on the
card.
There is a problem with the
selected picture and it
cannot be played back on
this camera.
Pictures taken by other
cameras take in [D], or
previously edited or
corrected pictures cannot be
edited or fixed.
The battery/card
compartment cover is open.
The battery is empty.
The card was not read. Or,
the card is not formatted.
SET
OK
There is an error in the
IN
internal memory.
SET
OK
The camera is not
connected to the computer
or printer correctly.
There is no paper in the
printer.
Corrective action
This card cannot be used. Insert a new
card.
The recorded image has been protected
(read-only) on a computer. Download the
image to a computer and cancel the read-
only setting.
Insert a card or erase unwanted data.
Before erasing, backup the data of
important pictures using the card, or
download such pictures to a computer.
Replace the card or erase unwanted data.
Before erasing, download important
pictures to a computer.
The internal memory or the card contains
no pictures.
Record pictures.
Use image processing software to view the
picture on a computer. If that cannot be
done, the image file is damaged.
Use image processing software to edit the
pictures.
Close the battery/card compartment cover.
Charge the battery.
• Select [CLEAN CARD], and press e.
Remove the card and wipe the contact
area with a soft dry cloth.
• Select [FORMAT] [YES] and press
e. All data on the card is erased.
Select [MEMORY FORMAT]
press e. All data in the internal memory
is erased.
Disconnect the camera and connect it
again correctly.
Load some paper in the printer.
[YES] and