InFocus SP-CWRS232 Product Note

Rs-232 network adapter card

Product:

This adapter allows you to connect your InFocus projector to a computer via a

null modem cable. You can then control the projector from the computer by using

the command line interface commands.

This package contains the adapter (part number 590-0284-00), two threaded

standoffs (206-0010-00), and this Product Note (009-0403-00).

Connecting the Adapter

To securely attach the RS-232 adapter to your projector, you must first remove two

screws on the projector's CableWizard connector, insert two threaded standoffs,

then insert the adapter and tighten the thumbscrews.

Using a small Phillips screwdriver, remove the 2 screws on the projector's

CableWizard connector (see figure below).

The connector is labeled with this icon:

vides space for the 2 standoffs included with the adapter.

Screw the 2 threaded standoffs into the holes.

Plug the adapter into the CableWizard connector.

Securely fasten the adapter to the projector with the thumbscrews.

Plug your null modem cable into the adapter and into your computer.

Product Note

RS-232 Adapter (SP-CWRS232)

CableWizard connector

adapter

null modem cable

. Removing these screws pro-

remove these 2 screws

and replace with standoffs

009-0403-00

Table of Contents

Do you have a question about the SP-CWRS232 and is the answer not in the manual?

Page 1 Product Note Product: RS-232 Adapter (SP-CWRS232) This adapter allows you to connect your InFocus projector to a computer via a null modem cable. You can then control the projector from the computer by using the command line interface commands. This package contains the adapter (part number 590-0284-00), two threaded standoffs (206-0010-00), and this Product Note (009-0403-00).
Page 2 Product Note RS232 Terminal Specifications-Communication configuration To control your projector from an LCD control panel, connect the null modem cable and set your computer’s serial port settings to match this communication configuration: Setting Value Bits per second 19,200 Data bits Parity None Stop bits...
Page 3 Note that each projector has its own subset of supported commands, so some commands listed may not apply to your projector. The Service & Support section of our website lists the specific commands for each projector. Visit our website at http://www.infocus.com/service for details.
Page 4 Video Source-Video (read only) Volume 0-80 Zoom For more information, call your InFocus dealer. You can also call InFocus directly at 1-800-294-6400. In Europe, call (31) 35-6474000. In Singapore, call (65) 334-9005. Please refer to your projector’s user’s guide for warranty information.