MerCruiser Axius SeaCore 496 MAG Owner's Manual page 103

The belt tensioner is designed to operate within the limits of arm movement provided by
the cast stops when the belt length and geometry are correct.
If the tensioner is contacting either of the limits during operation, check the mounting
brackets and the belt length. Loose brackets, bracket failure, accessory drive component
movement, incorrect belt length, or belt failure can cause the tensioner to contact the limits.
See your authorized MerCruiser dealer for service if these conditions exist.
Rapid release of the belt tensioner, or allowing the tensioner to snap back quickly, could
cause injury or product damage. Relieve the spring tension slowly.
1. Use a breaker bar and appropriate socket to hold back the tensioner and relieve the
belt tension. Rotate the tensioner away from belt until it stops. Remove the belt from
the idler pulley and slowly relieve the tension on the breaker bar.
Breaker bar with arrow in direction of movement to relieve tension
2. Remove the belt and reroute the replacement belt according to the belt routing diagram.
90-899883154 JANUARY 2008
a
a - Breaker bar
CAUTION
!
8115
Section 5 - Maintenance
Page 95