Advertisement
Rudders: : : :
Rudders
Rudders
Rudders
1. Remove the screws holding the servo covers from the rudder servo bay. Keep
the orientation of the servo cover correct, do not flip or rotate the servo
covers, as there may be slight variations in the screw holes and they may not
fit perfectly if you rotate the covers.
2. Mount the plastic brackets as indicated then mount the servos to the brackets.
3. Do not over tighten and strip the screws. Do not use any grommets or other
servo hardware. Vibration isn't a problem for jets which is why you don't need
to use the rubber grommets. Secure the screws with Loctite
4. Check the depth of the servo mount with the servo. Relieve if needed with a
sharp exacto knife.
5. Feed the wires for the servo to the hole provided that goes through the
fuselage.
6. Rough up the rudder horns and check the depth where they sit on the rudder.
Check the positioning as the hole in the horn should be directly over the hinge
point.
7. Hysol the control horns to the rudder.
8. Rough up all the hinges with 60grit sandpaper before gluing them into the
surface to ensure a good glue joint.
Advertisement
