GE GSD1250 Use And Care Manual page 13

PROBLEM
BLACK OR GRAY
MARKS ON DIS=S
WATER WON'T PUMP
OUT OF T~ TUB
TUB
SUDS ~ THE
LEAKS
MOTOR MMS
If you need more help.. call, toll free:
GE Answer Center"
800.626.2000
consumer information service
POSSIBLE CAUSE
Aluminum utensils often leave mmks when they rub against dishas. Remove marks
with a mild abrasive cleanser.
round the outlet on the tub bottom at the back of tie tub is noti. It is clean
water. It's there to keep the water sed lubricated.
If the entire bottom of the tub has water, you may have a drain problem. Clem the air
gap, if you have one. (See Care and Cleaning section,)
Check the kitchen sink. Is it draining well? You
If dishwasher drains into disposer, run dispser to clear. Be sure disposer is not
clogged,
DISHWASHER DE~RGENTS TO AVOD SUDS~Q.
To remove suds from the tub: Open the dishwasher. Let suds evaporate. Add 1 gallon
of cold water to the tub. Close and latch the dishwasher. Pump out
turning the control did until a drain period is reached.
Repeat if necessary.
to ovefflow. That's why it's so important to use a detergent that's
Suds can cause unit
designed for automatic dishwashers.
Spilling the rinse agent can cause foam during washing. This can lead to
Wipe up accidental spill of rinse agent with a damp cloth.
Dishwasher has not been used on a regular basis.
If you do not use your dishwasher often set it to fifl and pump out once every wink.
This will help keep the sed moist, and the garbage disposer clear.
detergents contain colorant (pigment or dyes) that wfil discolor tie tub
Some
interior with extended use. Check the detergent cup for signs of any discoloration.
If cup is di~olored, chage to detergent wibout any colorant.
water by slowly
13