Step 12 Completing The Installation - Samsung DW80H99 Series Installation Manual

Hide thumbs Also See for DW80H99 Series:

Table of Contents

Available languages

installing the dishwasher

STEP 12 COMPLETING THE INSTALLATION

1. Open the door and remove all foam, paper packaging, and unnecessary parts.

2. Turn on the circuit breaker you turned off before you began the installation.

3. Open the water supply valve to supply water to the dishwasher.

4. Turn on the dishwasher, and then select and run a cycle.

Check if the power turns on correctly and if there is any water leakage while the dishwasher

is operating. If no errors occur while it is operating, turn off the dishwasher, and then go to

Step 5 below.

If an error has occurred, turn off the dishwasher, close the water supply valve, and then

refer to the user manual or contact a service center 1-800-SAMSUNG (726-7864).

Make sure to check for water leakage on both ends of the water supply line and drain hose

connector.

CAUTION

5. Locate the sound absorber in front of base refer to the ﬁ gure below (ON SOME MODELS).

Check it the black rubber skirt (*applicable models only) should be located inside, and then

sound absorber will be covered it.

6. Conﬁ rm that the kick plate gasket is on the bottom of the kick plate. To install the kick plate,

refer to the ﬁ gure below.

22_ installing the dishwasher

installation_DW80H9950US-00151A-02_EN_140811.indd Sec3:22

2014-08-11

7:39:34

Table of Contents

Show Quick Links

Table of Contents