Summary of Contents for Little Labs multi z pip rev.b
Page 1
FRONT PANEL EARTH LIFT SWITCH hi z mid z LITTLE LABS HEAVY IRON CORE CUSTOM WOUND AUDIO TRANSFORMER lo z Balanced main XLR o less out, Line level tr multi z pip rev.b spkr Internal user configur...
Page 2
EARTH LIFT SWITCH hi z mid z LITTLE LABS HEAVY IRON CORE CUSTOM WOUND AUDIO lo z TRANSFORMER Balanced main XLR output. This ouput is available with three options. Line level transformer- less out, Line level transformer isolated out, or mic level/impedance transformer isolated out.
Page 3
EARTH LIFT SWITCH tape amp. Every custom mod that was asked of Little Labs over the past ten years, of which LITTLE LABS HEAVY IRON CORE CUSTOM WOUND AUDIO TRANSFORMER Balanced main XLR output. This ouput is available with three options. Line level transformer- there were many, has been incorporated into the new, but still compact, Multi Z PIP.
11. Pop on knob caps note line orientation. Passive Direct Box voltage loss ..........4 Active Direct Boxes and line level inputs ......4 That’s it! Little Labs Multi Z PIP gain structure ........5 Re-amp level .................6 Speaker outputs & speaker/amp simulators Direct signals with amp harmonic overtones ......5 Capturing the artist / instrument / amp performance ....5...
Page 5
er .washers. If you are replacing the input select switch assembly you will pull the two ribbon jumpers out of the 20 pin socket. You could at this point, if you really want to go all the way,unsolder the power sup- ply leads.
IMPEDANCE SELECTION THE BIG Non default option 1F Transformerless, the naked truth. If you want you can order the Multi Z PIP without an output transformer at all. The original Multi Z did not have The letter Z, common abbreviation for impedance. The Multi Z PIPs se- a transformer on the output.
Multi Z balanced feed to the main console. This enables the ground of the console, the ground of your keyboard, and the ground of the keyboard rack cue mixer to be isolated from each other. (Thus eliminating a source of possible ground loops). LO Z Lo Z, use on active instruments (on board preamp), or keyboards.
(low noise and low distortion ) is the result. inputs feeding your main output, which is a nice feature. The Little Labs Multi Z PIP is capable of putting out +32dB on the bal- In the mic transformer model, you can feed the mic level out trans- anced expansion output and the balanced main output (xlr 7).
Before feeding the Direct with speaker level read the cautions under the "Read this before using the Little Labs Multi Z PIP" section. Utilizing the speaker output of a musical instrument amplifier to feed the Multi Z PIP is one way to use the harmonic overtones of an amplifier as part of the direct signal.
SWITCH stomp box hi z to the volume pedal and the ring being the return to the pip. The lower insert mid z LITTLE LABS HEAVY IRON CORE send return CUSTOM WOUND AUDIO lo z TRANSFORMER Balanced main XLR output. This ouput is available with three options. Line level transformer- less out, Line level transformer isolated out, or mic level/impedance transformer isolated out.
Page 12
the default and custom configuration options for the multi z professional instrument preamp The following describes where the blue jumpers inside the PIP must be set in order for it to function, either in its default mode or other custom modes to suit your needs.
Page 13
Non default option 2A. This will turn the Instrument thru (jack 1) into a summing input jack. It will then function the same as the summing in (jack 2). This will sum after the main input stage with whatever is plugged into the instrument input (jack 8), and the summing in (jack 2).
Page 14
EARTH LIFT SWITCH hi z mid z LITTLE LABS HEAVY IRON CORE CUSTOM WOUND AUDIO TRANSFORMER lo z Balanced main XLR output. This ouput is available with three options. Line level transformer- less out, Line level transformer isolated out, or mic level/impedance transformer isolated out.