Changing The Flash Settings - Kodak easyshare p880 User Manual

Doing more with your camera

Changing the flash settings

NOTE:
Flash settings are preset for each picture-taking mode. Some of the flash settings may
not be available in all Capture or SCN modes. When you change to Auto or Red-eye in
some of these modes, it becomes the default until you change it.
NOTE: For rapid setting changes, see
Flash mode
Auto
Fill
Redeye
Slow
front
sync
Off
37
1
(Press again to exit.)
2
3
A blinking flash icon indicates the flash
page 43.
Flash fires
When the lighting conditions require it.
Every time you take a picture, regardless of the lighting conditions. Use
when the subject is in shadow or is "backlit" (when the light is behind
the subject). In low light, hold the camera steady or use a tripod.
Once, so the subject's eyes become accustomed to the flash, then fires
again when the picture is taken. If the lighting conditions require flash
but do not require Red-eye reduction, the flash may fire only once.
Regardless of the shutter speed and right after the shutter fully opens.
Only useful when slower shutter speeds are used. For other slow-flash
settings, see table on
Never.
.
Press
to highlight an option.
Press OK or Set.
is charging. Take the picture
when the blinking stops.
page 53.
www.kodak.com/go/support