Severe Warning Signs - Samsung ra21ptih User Manual

SEVERE WARNING SIGNS

FOR INSTALLATION
WARNING
• Do not install the refrigerator in a damp
place or place where it may come in contact
with water.
- Deteriorated insulation of electrical parts may
cause an electric shock or fire.
• Do not place this refrigerator in direct sunlight or
expose to the heat from stoves, room heaters or
other appliance.
• Do not install this appliance near a heater,
inflammable material.
• Do not install this appliance in a humid, oily or
dusty location, in a location exposed to direct
sunlight and water (rain drops).
• Do not install this appliance in a location where
gas may leak.
- This may result in electric shock or fire.
• Do not plug several appliances into the same
multiple power board.
The refrigerator should always be plugged into
its own individual electrical which has a voltage
rating that matched the rating plate.
- This provides the best performance and also
prevents overloading house wiring circuits, which
could cause a fire hazard from overheated wires.
• Plug the power plug into the wall socket firmly.
Do not use a damaged power plug, damaged
power cord or loose wall socket.
- This may result in electric shock or fire.
• Do not pull or excessively bend the power cord.
• Do not twist or tie the power cord.
- When moving the refrigerator, be careful not to
roll over or damage the power cord
- This may result in electric shock or fire.
• This appliance should be positioned in such a
way that it is accessible to the power plug.
- Failing to do so may result in electric shock or
fire due to electric leakage.
• Never unplug your refrigerator by pulling on the
power cord.
Always grip plug firmly and pull straight out from
the outlet.
- Damage to the cord may cause a short-circuit,
fire and /or electric shock.
• The installation or any service of this appliance
is recommended by a qualified technician or
service company.
- Failing to do so may result in electric shock,
fire, an explosion, problems with the product, or
injury.
DA68-02477A(0.0)-EN (Paolo-T).indd
before it is used.
• Insert the power plug with it's cord down.
- Otherwise the electric wire can be down and it
can cause fire and electric shock.
• Make sure that the power plug is not squashed
or damaged by the back of the refrigerator.
• When moving the refrigerator, be careful not to
roll over or damage the power cord.
- This constitutes a fire hazard.
• The appliance must be positioned so that the
plug is accessible after installation.
any power leakages or electric shocks caused by
current leakage from the refrigerator.
• Never use gas pipes, telephone lines or other
potential lightening rods as ground.
- Improper use of the ground plug can result in
electric shock.
its service agent.
cAuTION
- If your refrigerator is not level, the internal cooling
system may not work correctly.
• Keep ventilation opening in the appliance
enclosure or mounting structure clear of
obstruction.
• Allow the appliance to stand for 2 hours after
installation.
• Install your appliance on a level and hard floor
that can support its weight.
- Failing to do so may result in abnormal
vibrations, noise, or problems with the product.
3
• This refrigerator must be properly installed
and located in accordance with the manual
• The refrigerator must be grounded.
- You must ground the refrigerator to prevent
• If the power cord is damaged, have it
replaced immediately by the manufacturer or
cAuTION SIGNS FOR
INSTALLATION
• Allow sufficient space to install the
refrigerator on a flat surface.
safety information
_3
2010.12.17 10:8:22 AM