Advertisement
Installing Memory Module
1. Lay the Z91N unit bottom side up on the bench and make sure the power is
disconnected, and the battery is removed.
2. Remove the 2 screws that secure the DDR door and slightly slide the cover to the side
to remover it.
3. Insert the DDR memory module at the angle of 30 degree into the SO-DIMM slot with
the notch matching the key of the slot. Push the module fully into the contacts, and
push down into the side latches which secure the module.
4. You can also install the second memory module into the other socket.
5. Put the cover back, and secure the two screws.
DDR door
6
Advertisement
