Preparation; Accessories - LG 42PT200 Owner's Manual

PREPARATION

ACCESSORIES

Ensure that the following accessories are included with your TV. If an accessory is missing, please contact the
dealer where you purchased the TV.
The accessories included may differ from the images below.
Owner's Manual
(For 42/50PT200, 42/50PT330, 42/50PT350,
42/50PT350C, 42/50PT250U, 50PV400,
50PV430, 50PV450, 50PV450C, 50PV550U)
x 4
M4x26
Screws for stand assembly
(Refer to P.13, 14)
Polishing Cloth
(Not included with all models)
I
How to use the Ferrite Core
1. Use the ferrite core to reduce the electromagnetic interference in the PC audio cable.
Wind the PC audio cable on the ferrite core thrice. Place the ferrite core close to the TV.
[to an External device]
2. Use the ferrite core to reduce the electromagnetic interference in the power cable.
Wind the power cable on the ferrite core once. Place the ferrite core close to the TV.
[to a wall plug]
3. Use the ferrite core to reduce the electromagnetic interference in the power cable.
Wind the power cable on the ferrite core once. Place the ferrite core close to the TV and a wall plug.
[to a wall plug]
- If there is one ferrite core, follow as shown in Figure 1.
- If there are two ferrite cores, follow as shown in Figures 1 and 2.
- If there are three ferrite cores, follow as shown in Figures 1 and 3.
Downloaded From TV-Manual.com Manuals
Protection Cover and Tape
(Refer to P.14)
CD Manual
(For 60PV400, 60PV430, 60PV450,
60PV450C, 60PV550U)
x 3
M5x14.5
M4x28
Screws for stand assembly
(Refer to P.13, 14)
* Wipe spots on the exterior only with
the polishing cloth.
* Do not wipe roughly when removing
spots. Excessive pressure may cause
scratch or discoloration.
10 mm (+/-5 mm)
[Figure 1]
[Figure 2]
[Figure 3]
Power Cord
x 4 x 3
M5x24
Remote Control,
Batteries (AAA)
O O p p t t i i o o n n E E x x t t r r a a s s
D-sub 15 pin Cable
[to the TV]
[Cross Section of
Ferrite Core]
[to the TV]
[Cross Section of
Ferrite Core]
[to the TV]
[Cross Section of
Ferrite Core]
Ferrite Core
(Depending on model)
Power Cord Holder
1.5V 1.5V
Cable Holder
When using the VGA (D-sub 15 pin cable)
PC connection, the user must use shielded
signal interface cables with ferrite cores to
maintain standards compliance.
9