Advertisement
2.3 Connecting the power
The MTX-ROUTER HELIOS II series can be powered by connecting a power source to the terminal
block. It supports dual 9 to 48VDC power inputs. Following picture is the power terminal block
pin assignments. Please check carefully and connect to the right power requirements and
polarity.
*Note : If both of power source 1 and power source 2 are connected, the device will choose
power source 1 first. If power outage occurred from power source 1, this device will switch to
power source 2 automatically and seamlessly.
The maximum power consumption of IOG761‐0P001 is 15.5W.
2.4 Connecting to the device
To start the configuration of the MTX-Router Helios II, plug an Ethernet cable to any of the 4
Ethernet ports of the router and the other side of the cable directly to the Ethernet port of your
computer. Your computer must get the IP by DHCP or fixed IP into the same range of the router
192.168.1.x.
After this, open your web explorer and type the default IP Address
www.mtxm2m.com
www.matrix.es
MTX Terminals® by MATRIX ELECTRONICA S.L.U.
MTX-HELIOS II
http://192.168.1.2
2014/05
Page 4
4
/
6
Advertisement
