Synchronizing Dual Helms Prior To Station Transfer; Zero Effort Features - MerCruiser SeaCore 5.0 User Manual

Section 2 - Getting to Know Your Power Package
3. Press throttle only/station select button once. The "ACTIVE" light will illuminate to
indicate the remote control station is in control of the engine.
4. The active light will switch off at the original remote control station.

SYNCHRONIZING DUAL HELMS PRIOR TO STATION TRANSFER

Pressing the station select button and holding it in allows the boat operator 10 seconds to
match up the control handle settings at the new station with the handle settings that are at
the old (to be inactive) station. If the handles are not matched, the neutral light will flash.
The light blinks faster as the handles are nearing match position. Once the light stays on
continuously, the handles are matched and the button can be released. Transfer process
is complete and the new station is now in control. If the button is held for over 10 seconds,
the station transfer is cancelled.

Zero Effort Features

a
Shift Lever - Shift functions are controlled by the movement of the shift lever. Shift into
reverse by moving the shift lever to its aft position. Shift into neutral by moving the shift
lever to its center position. Shift into forward by moving the shift lever to its forward position.
Throttle Lever - Throttle functions are controlled by the movement of the throttle lever.
Increase the RPM by moving the throttle lever forward. Achieve Wide Open Throttle (WOT)
by placing the throttle lever in its full forward position. Decrease RPM by moving the throttle
lever back. Achieve minimum RPM (idle) by placing the throttle lever in its full aft position.
Trim/Tilt Switch - Refer to Power Trim.
Page 34
ACTIVE
THROTTLE
ONLY
STATION SELECT
a
a - Active light
b
a - Shift ever
b - Throttle lever
b
ACTIVE
a
b - Throttle only/station select button
c
c - Trim/tilt switch
90-899883169 DECEMBER 2007
b
SYNC
THROTTLE
ONLY
STAT ION SELECT
3433
5656